We Also Talked A Lot About The Window Cleaning Machine In The Previous Introduction. Many Friends May Have Seen It Outside The High-rise Building. In Fact, It Is Used For The Operation Of The Outer Wall Of The High-rise Building. Today We Mainly Introduce The Things That Need To Be Paid Attention To When Installing And Designing The Track Type Window Cleaning Machine. First Of All, We Should Consider The Weight Of Each Component Of The Window Cleaner, The Weight Of The Guide Rail, And The Force Caused By The Operation. Secondly, The Designed Guide Rail Base Shall Conform To The Building Modulus, And Enough Space For Concrete Pouring And Vibration Shall Be Reserved. Thirdly, The Supporting Points Of The Track Should Not Be Too Dense, Their Spacing Should Not Be Less Than 1.5m, And They Should Be Simplified To Simply Supported Beams Under Large Load. Fourth, It Should Be Able To Bear More Than 2 Times Of The Rated Load, And Do A Good Job In Anti Rust And Anti-corrosion Of Relevant Parts. Fifthly, We Should Consider Some Reactions Caused By The Change Of Temperature. In The Place Where The Temperature Difference Is Large, We Should Choose The Profile With Small Cross-section, Which Can Reduce The Impact Of Temperature Stress. Sixth, The Welding Of Limit Baffle Should Be Carried Out At The End Of The Track, And The Requirements Of Certain Thickness, Width And Height Should Be Met. Seventh, If You Want To Connect The Outer Joint, You Should Use Groove Welding. The Above Seven Steps Are All The Points We Need To Pay Attention To In The Design And Installation. If There Is Any Incomplete Introduction, Please Forgive Me. I Hope I Can Help You.